6 Wheel Wireless Tire Pressure
Monitor
PressurePro
Easy to Install!
No tools are necessary to install PressurePro
TMPS and the system is simple to operate.
A wireless tire air pressure Sensor simply
screws onto the valve stem, replacing the valve stem cap.
The Monitor is powered by plugging into the lighter
accessory in the vehicle and displays current tire
pressure for each tire and can alert to low tire
pressures with both a visual and audible
warning.
The Sensors constantly read the tire pressure
and transmit low-pressure readings when they occur. When
tire pressure is low, the Monitor identifies the low-tire
position with an audible beep, a blinking light for that
location, and flashes the real-time pressure to the
operator.
PressurePro continuously monitors tire pressure
to assist in maximizing a
vehicle's handling, braking, acceleration and tire
life. The early detection of low tire
pressures improves the possibility of repair and reduces
the risk of permanent tire or wheel damage.
PressurePro is an investment in your vehicle and
in your own safety and the safety of those with you.
PressurePro gives you confidence in your tires
performance and peace of mind while driving.
This kit includes:
Monitor,
6 Sensors,
Velcro
Pads,
Power
Cord,
Built
In Antenna,
Complete
installation/operating instructions.
Our Price $490 
How do the Sensors work with inside
duals and inward facing valve stems?
PressurePro saves you the trouble of trying to reach the inside
tires to check pressure. The system monitors tire pressure
constantly, alerting when pressure is low. No need to manually
check tire pressures as frequently as you did before you
installed PressurePro!
Do I need to re-balance my tires when
using a Sensor?
The 2/3 oz. Sensors monitoring large tires (RV/Truck) seldom
necessitate a tire re-balance. Smaller tires may require adding
a 2/3 oz. stick-on weight opposite the valve stem.
What is the cold running reference
pressure?
PressurePro Sensors automatically
access the pressure in a tire when screwed onto the valve
stems. Removing the Sensor from the valve stem for 60 seconds
will delete the old reference cold running pressure and allow
the Sensor to accept a new cold running reference pressure when
screwed back on. We suggest installing the Sensors in the early
morning when temperatures are cooler, so as not to cause alerts
during the cooler evenings. For example, if you are travelling
during the middle of the day and decide to stop to check the
tire pressures with a gauge, the working pressure of the warm
tires may be 15 psi higher than the early morning cold running
pressure. PressurePro will "reset" to this new running pressure
(which is higher than it should be). This may cause a false
alert when cooler night temperatures occur, or when going up in
the mountains where it is cooler. To correct this, unplug the
Monitor to turn off the alarm if it is alerting at night, and
the next morning, take each Sensor off, wait one minute, and
put them back on. They will again reset to a new, lower cold
running reference (baseline) pressure.
| 